Joined: Sat Mar 03, 2012 4:48 am
Posts: 1
|
|
Hello, I am not able to load the config iso from my wode. I load from ram1 Wode RO 1 - GU Wode Config ISO and the gamecube logo shows up in the Wii menu. The LCD has 2 Reads 8 KB. I then use the wiimote to start the disc and I get a black screen. The LCD says ISO Ejected and the screen stays black.
I just installed the Wode today and updated it to the latest firmware. So far I am able to load gamecube iso's from a memory stick. I used the files on here to downgrade back to 1.0 firmware and then I updated again and have had no luck.
Boot Ver: 01.01
Wode Ver: 02.8E
FPGA Ver: 02.00
HW Ver: 1
Wii firmware is 4.3u
Any help would be appreciated as I believe the Config ISO is the Wode Menu that will load onto screen.
|
|
