Wode Jukebox

I hope this is the right place for this issue.

Until now i used Gecko OS Mod for hacking my Gamecube Games.
But now i had my first game where the assembly moved and was not static.
Gecko OS Mod has an old Gecko Cheat engine which doesn't support F2 Codetypes, so i wanted to switch to the newer Neogamma r9 b56.

The problem is, that i can play gamecube games from originals and burned disc with "wode flat mode" on Neogamma without problems.
But if i start it from the connected hdd the wode gets confused / messed up.
The blue light shines the whole time, only 2-3 reads and some KB loaded.
Then i get blackscreen, 1-2 wii disc errors, and wode is ok again.
I have the rather new wode firmware 2.8A so i think its up to date.

Maybe TheGuru or some other programmer could look into this issue.

ill try to look for a fix, could you write me all the settings of your wode.

TG


P.S: just to try, could you test to enable the stalth mode ON

Thx for your help

My settings are as follows:
Boot Ver 01.01
Wode Ver 02.8A
FPGA Ver 02.00
HW Ver 1
Settings->Wii Region EUR
Settings->Game Patching->Region Patch ON;Updates NO
Settings->Wode Settings->Auto Load LAST;Display Title ID;Free Space OFF;Stealth Mode OFF

P.S. I also thought Stealth Mode could be solve this problem, because it runs flawlessly with Riivolution, but i had no luck.
Sadly Stealth mode didn't solve this problem.

Hi TheGuru, is there any progress made yet?
Could you reproduce the bug?